Language Aid 1.1.2 is out!

March 1st, 2008
Spencer Nielsen Follow snielsen42 on Twitter

One of the things I hear most often while providing support for Langauge Aid is something along the lines of “I hovered my cursor over text in some program, hit the lookup trigger and it didn’t do anything/grabbed the wrong text.” This is sometimes because the application they want to grab text from does not support the Accessibility API or sometimes because what they were hovering over wasn’t really text. Thus I have added a feature in version 1.1.2 that should help alleviate confusion.

highlight

Now in Language Aid 1.1.2 if you hold down the lookup trigger for more than one second, a highlight bubble will appear containing the text that will be grabbed if you let up your lookup trigger. You can also move the cursor around while holding the lookup trigger to see the exact text that would be grabbed from any point that your mouse cursor can hover over. So now if you are unsure about what text will be sent to the plugin, simply hold down the lookup trigger and move the mouse cursor around until you find the text you want. The highlight bubble is also slightly translucent so you can see the text under it.

I have also slightly overhauled the main Language Aid website to focus more on the the three different ways that you can use Language Aid to grab text. I have added short videos that explain and demonstrate each way. Also, a quick side note on Quicktime video encoding…the “Prepare for Internet Streaming” setting is BAD. When run in my web browser I found that my videos would often play for a bit, then the video would freeze but the progress slider would keep moving. This would continue until the end of the video. If you scrubbed through the video it would seem to display fine. However, if you scrubbed to a section in the video and then pressed play, it would play for a bit and then freeze again. Strangely enough, when played through Quicktime Player this did not happen quite as much but still occasionally would occur. I found that when I turned off the internet streaming setting this behavior stopped. Also, setting my H.264 keyframes setting to “Automatic” from 24 seemed to cut my file sizes in half. I suppose the moral of the story is that it pays to deviate from the default video encoding settings.

Leave a Reply

Entries (RSS) and Comments (RSS).